GDS introduces the KNX - Alarm System Interfaces family products.

We created a device that can communicate with Paradox & Caddx alarm systems. It provides:
- Bidirectional communication
- Visualization
- The usage of the alarm information can control A / C, lighting and motion detection
- Update on status change
- Arming - disarming alarm system
- Display the alarm’s keypad information

PBI-064
Paradox to KNX-BUS Interface

Basic Device features

• Sending the state of each zone (Transmits on change)
• Provides the partition Partition (Armed-Disarmed , Trouble/ No trouble)
• Sending of states can be enabled/disabled in runtime (Armed-Disarmed / Alarm-OK)
• New firmware can be loaded when available
• Communication error with alarm system is indicated with individual object
• Safety feature overwrites attempt to affect real zone status if another device writes to same group address
• Remote restart of the device

Unit interface connection PBI-064 for programming

1. Connect the unit’s interface power supply (6-12 VDC).
2. Connect the RS-232 port (Program mode/Alarm Mode) of the unit interface with the Computer via a female-female RS-232 crossed cable.
 The power of KNX BUS connection is not necessary during the programming of the device.

Unit interface connection PBI-064 for operation with the alarm system

1. Connect the device to KNX BUS (20-33 VDC).
2. Connect the port RS-232 (program mode/alarm mode) of the unit interface with the subunit APR-PRT3 of the alarm system (which is connected to the data BUS of the alarm) via a male-female RS -232 straight wire.
3. Connect the power supply of the unit PBI-192 Interface (6-12 VDC).

ASK FOR PRICE